Kohler K-7338 Guia De Instalacion página 5

Finished Wall
Elbow
Pipe Nipple
Wall Shank
X
2. Install the Wall Shanks
Remove the caps from the pipe nipples.
Reinstall the wall shanks to the pipe nipples.
Measure and note the distance "X" from the end of the wall
shanks to the finished wall.
Remove the wall shanks.
Remove the pipe nipples and measure their length.
Subtract distance "X" from the length of the pipe nipples. Discard
the pipe nipples and replace them with ones of proper length.
Apply sealant tape to both ends of the pipe nipples, then insert
the pipe nipples into the elbows.
Thread the wall shanks to the pipe nipples, then tighten with a
3/8" hex wrench.
For each wall shank, ensure the distance from the end of the wall
shank to the finished wall is equal. Adjust if needed.
Kohler Co. 5 1069114-2-A