BGS technic 8385 Manual De Instrucciones página 27

4. If more than one DTC is found, use UP/DOWN button, as necessary, until all the codes have been
shown up. If no codes are detected, a "No codes are stored in the module!" message displays on
the screen. If the code definition is not found in the built in DTC library, a "DTC definitions not
found! Please refer to User's Manual!" message comes up prompting you to look up the definition
in the vehicle service manual.
5. Press N button to return to previous menu.
Erasing Codes
CAUTION: Do not erase the codes before the system has been checked completely by a technician.
This function is performed with key on engine off (KOEO
1. Use UP/DOWN button to select Erase Codes
from Diagnostics Menu and press Y button.
2. A warning message comes up asking for your
confirmation.
If you do not wish to proceed to erase the codes, press N button or use UP/DOWN button to select
NO and then press Y button to exit. A "Command canceled!" message shows up. Press any key or
wait a few seconds to return.
3. Press Y button to erase.
If the codes are cleared successfully, an "Erase Done!" message shows up.
If the codes are not cleared, then an "Erase Failure. Turn Key on with Engine off!" message
displays.
Deactivate Brake
WARNING: Deactivate the EPB system before carrying out any maintenance/service work on the
brakes such as changing of pads, discs and callipers!
Use proper tools to avoid the risk of body injuries of mechanics and technicians and damage to the
brake system. Make sure the vehicle is properly blocked before deactivation of the system.
1. To deactivate the EPB functions, use UP/DOWN
button to select
Deactivate Brake from Select Function menu and
press Y button.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
6
. Do not start the engine.
)
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed