BGS technic 8385 Manual De Instrucciones página 28

2. Use UP/DOWN button to select the purpose of
deactivating the brake.
Note: Please select the purpose of activation properly. For Pad Change is used to open the brakes
completely for change of worn pads. If you just intend to do repairs on the brakes other than changing
the pads, please select For Repair. If For Repair is selected, the brakes will not open wide enough for
pad change and it isn't necessary to do the adaptation for Audi A8 either.
3. Wait a few minutes while the tool is deactivating
the brakes. When they are deactivated
successfully, a "Deactivation Done!" message
comes up:
If the tool fails to open the brake pads, "Deactivation Failed! Please try again!" message comes up.
- Verify that the ignition is ON;
- Check if the brake tool's OBD II connector is securely connected to the vehicle's DLC;
- Check that the park brake is released;
- Turn the ignition off and turn it back on 10s later;
- Repeat the process.
If the "Deactivation Failed!" message does not go away, then contact your local distributor or the
manufacturer's customer service department for assistance.
4. Press any key or wait a few seconds to return to previous menu.
Activate Brake
WARNING: The EPB system must be activated after finishing the maintenance/service work on the
brakes. Make sure the vehicle is properly blocked before activation of the system.
1. To close the brake pads after finishing the
maintenance/service work on the brakes, use
UP/DOWN button to select Activate Brake from
Select Function menu and press Y button.
2. Wait a few minutes while the device is activating
the brakes. When they are activated successfully,
following screen shows:
Note: It is necessary to do the adaptation only when brake pads have been changed. So if you did not
change them, please use UP/DOWN button to select NO to exit.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
7
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed