BGS technic 8385 Manual De Instrucciones página 35

- Open bleeder screw at front left brake caliper.
- Operate brake pedal at least 5 times and release again (pump.
- Stop pumping once the brake fluid flows out free of bubbles.
- Hold bleeder hose tight.
20. Press Y button to continue.
21. Wait a few seconds until following screen
shows
The number "X" on the upper left corner of screen indicates how many times you need to operate the
brake pedal.
22. Operate the brake pedal at least 5 times as instructed.
23. Follow onscreen instructions to finish the eighth phase.
- Hold bleeder hose tight.
24. Press Y button to continue.
25. Follow onscreen instructions to finish the ninth phase.
- Close bleeder screw at front left brake caliper.
- Open bleeder screw at front rig ht brake caliper.
- Operate brake pedal at least 5 times and release again (pump.
- Stop pumping once the brake fluid flows out free of bubbles.
- Hold bleeder hose tight.
26. Press Y button to continue.
27. Wait a few seconds until following screen
shows
28. Operate the brake pedal at least 5 times as instructed.
29. Follow onscreen instructions to finish the tenth phase.
- Hold bleeder hose tight.
30. Press Y button to continue.
31. Follow onscreen instructions to finish the eleventh phase.
- Close bleeder screw at front rig ht brake caliper.
- All bleeder screws are closed.
- Brake system venting has been completed.
- Set filling and bleeding unit pressureless.
- Leave filling and bleeding unit connected.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
14
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed