Regulator Malfunction Message - E.L.M. Leblanc TR 100 Instrucciones De Instalación

TR 100
Before leaving the house the regulator is set
to the mode required at return (automatic op-
eration mode or continuous heating opera-
tion).
Then the switching contact of the remote con-
trol switch is deactivated, the regulator is op-
erating in the economical operating mode.
The respective red control light (l) is off.
Appears simultaneously in the display:
If the switching contact is activated (e.g. by a
coded telephone signal) the regulator oper-
ates in the pre-set operating mode.
It will be warm in the house late at night/
Tip
early in the morning if the regulator is set to
the position (continuous heating) (g) before
leaving the house, and the switch is deactivat-
ed afterwards. Do not forget to set the regula-
tor back to "automatic operating mode" after
returning to the house.
If the house is left for a longer period you
should consider that it could become a lot
cooler (walls could cool down etc.) and there-
fore it will take a longer time to heat up. Switch
the heating system on in time.
7

Regulator Malfunction Message

Malfunction remote indicator
(not available with all heating systems)
For heating equipment with Bosch Heatronic,
a malfunction in the heating eequipment is
routed to the regulator.
If the heating system has a malfunction mes-
sage the control light will indicate (l).
Note: In this case please proceed as stat-
ed in the operating instructions of
the heating unit or contact your lo-
cal expert for heating systems.
25