Restore Default; Data Format - Datalogic DRAGON D Serie Guía Rápida

1 DEFAULT
UK Read the RESTORE DEFAULT.
I Leggere il codice che ripristina i default.
Lecture du code de configuration par défaut.
F
Lesen Sie den Restore Default Code, um die
D
Werkseinstellung wieder herzustellen.
Leer el código de restauración predefinida.
E
RS232 DEFAULT SETTINGS
9600 baud, no parity, 8 data bits, 1 stop bit, no
handshaking, delay disabled, rx timeout 5 sec., ack/nack
protocol disabled, FIFO enabled, serial trigger lock
disabled;

DATA FORMAT

code length not transmitted, no header, terminator =
CR-LF, character replacement disabled
WEDGE DEFAULT SETTINGS
USA keyboard, caps lock Auto-Recognition enabled, num
lock unchanged, inter-character and inter-code delays
disabled, control character emulation = ctrl+shift+key;
DATA FORMAT
code length not transmitted, no header, terminator =
ENTER, character replacement disabled
PEN EMULATION DEFAULT SETTINGS
interpret operating mode, conversion to code 39 disabled,
output level normal, idle level normal, minimum output
pulse 600 µs, overflow medium, inter-block delay disabled
POWER SAVE
sleep state disabled
READING PARAMETERS
trigger type = hardware, trigger signal = level, no trigger
timeout, Flash On = 1 sec, Flash Off = 0.6 sec, one read
per cycle, safety time 0.5 sec, beeper intensity high, tone 2,
aiming spot disabled

RESTORE DEFAULT

: code identifier disabled, no field adjustment,
: code identifier disabled, no field adjustment,