Restore Default - Datalogic FireScan D111 Guía Rápida

1 DEFAULT
UK
Read the RESTORE DEFAULT code.
I
Leggere il codice che ripristina i default.
F
Lire le code de configuration par défaut.
D Lesen Sie den Restore Default Code, um die
Werkseinstellung wieder herzustellen.
E Leer el código de restaurar los parámetros de
fábrica.
RS232 DEFAULT SETTINGS
9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking,
delay disabled, rx timeout 5 sec., ack/nack disabled, fifo
enabled, serial trigger lock disabled;
DATA FORMAT
code length not transmitted, no header, terminator = CR-LF,
character replacement disabled
IBM DEFAULT SETTINGS
DATA FORMAT
header, no terminator
POWER SAVE
sleep disabled
READING PARAMETERS
hardware trigger, trigger active level, no trigger timeout,
Flash On = 1 sec, Flash Off = .6 sec, one read per cycle,
safety time .5 sec, beeper intensity high, tone 2, beeper type
monotone, beeper length short, aiming system disabled

RESTORE DEFAULT

Ì$+$*oÎ
: code identifier disabled, no field adjustment,
: IBM Standard, code identifier disabled, no