Auto Power Off; Replacing The Battery; Accessories - GRUPO temper KOBAN KP 2600 Manual Del Usuario

Pinza amperimétrica digital con maxilar abierto
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Audible continuity and diode
Range
If continuity exists (about less than 30Ω), built-in buzzer will
sound.
Show the approx. Forward voltage of the diode.
Duty cycle: 0.1% to 99.9%

Auto power off

To extend the battery life, Auto
Power Off function is provided. If no
key operations of range changing
happen about 30 minutes, the meter
will be turned off automatically. To
turn it on, rotate the rotary switch or
push any function buttons only.

Replacing the battery

Warning
To avoid electrical shock or
personal injury, remove the test
leads and any input signals before
replacing the battery. Replace only
with same type of battery.
When the electrical tester displays
the "
" mark or the backlight
be not very lit, the battery must
be replaced to maintain proper
operation. Use the following
procedure to replacing the battery:
1. The Rotary Switch is used to select
OFF. Disconnect test leads from
any live source and remove the test
www.grupotemper.com
Open jaw digit electrical tester
Description
leads from the input terminals.
2. Remove screws on the battery
cover and open the cover.
3. Remove the exhausted battery
and replace with a new 9-voltage
battery (IEC 6F22 JIS 006P NEDA
1604 type).
4. Never use the multimeter unless
the battery cover is in place and
fastened fully.

Accessories

• Operator's instruction manual
• Set of test leads
• Gift box
• 9 volt battery (IEC 6F22 JIS 006P
NEDA 1604 type).
Caution
Using this appliance in an
environment with a strong
radiated radio-frequency
electromagnetic field
(approximately 3V/m) may
influence its measuring accuracy.
Instructions manual |
KP 2600
25

Publicidad

Capítulos

Tabla de contenido
loading

Productos relacionados para GRUPO temper KOBAN KP 2600

Tabla de contenido