SATA 51325 Manual Del Uso página 18

This tool applies action mode switch button, and you can choose a mode suitable for your work needs through this knob. When only need
rotating, make the arrow on the knob point to the symbol
point to the symbol on the tool.
Note:
1）Please make sure that the knob is completely set on the required symbols. If the knob is in the halfway position betweenthe
two modes, the tool may be damaged
2） The knob can be rotated after the tool is completely stopped
Torque Limiter:
When a certain torque level is reached, the torque limiter begins to work. The motor will be out of the output shaft. At this point the bit
will stop turning.
Note:
1 ）Once the torque limiter moves, turn off the tool power switch immediately. This helps prevent the abrasion of the tools
2）The drilling bit, such as a hole saw, is easily clamped or locked in the hole and is not suitable for simultaneous use with the
tool. Because these tools will cause the torque limiter to start too frequently
Installation:
Note:
Before operating on the tool, make sure that turn off the power switch and remove the plug
Install or uninstall a drilling bit:
Before installing the drilling bit, clean the bitand scribble the bit oil.
Insert the bit into the tool, rotate it and push it into the drill until it is occluded.
After installation, be sure to pull the drill outward to confirm that the bit is fixed. When the drill bit is unloaded, pull the chuck shell
downward and pull out the drill bit.
18
51325/05157
1 ）Side handle
2）Unscrewing
3）Tighten
中文
on the tool. When need rotating and attacking, make the arrow on the knob
EN DE RU KO PT JA ES