Safety Notes; Important Notes; Multi-Protocol Operation - Trix 24126 Manual De Instrucciones

Safety Notes

• This model is only to be used with the operating system it
is designed for.
• Analog max. 15 volts DC, digital max. 22 volts AC.
• This model must never be supplied with power from more
than one power pack.
• Please make note of the safety notes in the instructions
for your operating system.
• The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
model is to be run in conventional operation. The 611
655 interference suppression set is to be used for this
purpose. The interference suppression set is not suitable
for digital operation.
• WARNING! Sharp edges and points required for operation.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• The LEDs in this item correspond to Laser Class 1 accor-
ding to Standard EN 60825-1.

Important Notes

• This specially prepared model is an exclusive version,
which reproduces the condition of the original after many
years of operation in wind and weather.
Therefore, please handle the model with special care
and avoid, scratching, rubbing, or wiping the surface and
the details. Please do not use liquid cleaners or cleaning
solutions.
10
• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or
spare parts.
• The warranty card included with this product specifies
the warranty conditions.
• Disposing: www.maerklin.com/en/imprint.html
• The full range of functions is only available under Trix
Systems and under DCC and mfx.
• Various controllable functions.
• Only the work lights, the rotary snowplow blade, and the
smoke unit are available in analog operation.
• Minimum radius for operation is 360 mm/14-3/16".

Multi-Protocol Operation

Analog Operation
This decoder can also be operated on analog layouts or ar-
eas of track that are analog. The decoder recognizes alter-
nating current (DC) and automatically adapts to the analog
track voltage. All functions that were set under mfx or DCC
for analog operation are active (see Digital Operation).
Digital Operation
The decoders are multi-protocol decoders. These decoders
can be used under the following digital protocols: mfx, DCC
or MM.
Address set at the factory: DCC 03 / MM 52