Incubator Operation - Selecta APL-54 Manual De Instrucciones

MANUAL DE INSTRUCCIONES
MAIN SCREEN (START)
Fig 8.1 Screen to set temperature and time.
Fig 8.2 Screen to stop a cycle.
J
.P. SELECTA s.a.u.
CODIGO 80390 REV A
8. Incubator Operation
All the equipment functions are established through the touch screen.
Press gently with your finger in the center of each icon.
This screen shows the status of the oven before disconnecting it by means
of the main switch (0/I).
This allows the oven to resume its task in the event of a power cut.
8.1 Set temperature and working time
For most applications, this is the usual work method. If you need to create
temperature profiles or program the start-up of the oven automatically,
follow the steps in section 7.3.
To select the working temperature:
- From the MAIN SCREEN, click on the value to be modified. The frame
of the modifiable parameter will be boxed in yellow. In the example, the
temperature can be modified.
The + and - keys appear to increase / decrease the value of the ad-
justment.
- After a few seconds without pressing any key, the yellow frame disap-
pears and the adjusted value is selected.
- The same operation can be performed to modify the working time or
the temperature ramp.
A time of --h --m establishes a continuous operation.
8.2 Start / Stop the cycle
- From the MAIN SCREEN press:
RUN to start the cycle (the icon will change its appearance with
the STOP message).
STOP to stop the cycle (the icon will change its appearance with
the RUN message).
Note: When the duty cycle is in operation, a heat or cold symbol
appears depending on the type of energy that the heating element
is generating.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - http://www.grupo-selecta.com
01/2021 Pag.: 23
Tel 34 93 770 08 77 Fax 34 93 770 23 62