XYZ Printing Da Vinci nano w Guía Rápida página 5

Printer Setup
Installing the Filament
Lower the filament spool
01
holder on the back side of
the printer until horizontal.
Remove Print Bed
Open the hold-open
04
component and take out
the print bed.
• The filament will load better when the tip of the filament is cut at a 45° angle.
Note
• When the printer is not in use, raise the filament spool.
• If the room temperature is below 25℃ / 77° F, apply some glue to the bed tape for better part
adhesion.
Place the assembled
02
filament spool (with the
spool ring) on the spool
holder.
Stick the bed tape onto the
05
print bed. (align center)
Note: The bed tape is reusable,
and only needs to be replaced
when it is worn out.
45°
The filament will load
03
better when the tip of the
filament is cut at a 45°
angle.
5