Software Functional Descriptions
Interface Introduction
Manually adjust the movement of X/Y/Z
Axis for printer maintenance.
Note
Jog Mode
Please follow the on-screen
instructions.
Print bed calibration may be
implemented before the printing
process.
Calibrate
Move the extruder module to the
lower left corner of the printing
area. Please refer to the calibrate
instructions provided by the
software.
Automatic horizontal calibration
Automatic horizontal calibration
may either be ON or OFF. Default:
ON.
The printer would automatically
Others
implement horizontal calibration
and compensation accordingly.
Printing speed will be improved if
automatic horizontal calibration
has been switched to OFF.
However, this may affect printing
quality.
Please upgrade the latest
firmware version for the best
printing quality of the printer.
FW upgrade
1. First click on Home Axes.
The extruder module will be
returned to the initial axis
position.
2. You may manually enter
the adjustment value:
Range: 1 to 150; step: 1 mm
SetUp
Z-Offset function will help you to
adjust the printing distance between
the print bed and extruder module.
Each adjustment has a step of 0.05
mm.
Z-Offset
Buzzer
Buzzer may either be ON or
OFF. Default: ON.
When the buzzer is turned
on, the printer will output
an audible signal when a
button is pressed, receiving
data, print job is finished, or
issue is detected.
Information related to printer
setting.
Info
Move extruder module
rightwards and leftwards.
Move extruder module
forwards and backwards.
Move the print axis (Z-AXIS)
upwards and downwards.
Restore Default
Click Restore Default to
reset to default setting.
9