Guarantee; Problem Identification And Handling; Disposal - FINO JETSTEAM PRO Información De Usuario

10. Guarantee

Our technical recommendations of application are
based on our own experiences and tests and should
only be regarded as guidelines. It rests with the skills
and experience of the user to verify that the products
supplied by us are suitable for the intended proce-
dures. Our products are undergoing a continuous
further development. We reserve the right of
changes in construction and composition. It is
understood that we guarantee the impeccable quali-
ty of our products.

11. Problem identification and handling

1. The device does not work at all.
• Check whether the plug is connected
properly to the socket.
• Check whether the fuse of the building
installation has been triggered.
• Check the fuse of the device and replace if
necessary (see 6.2).
2. Only little steam is emitted, the device takes
very long to heat up.
• The device is calcified. Descale device (see 6.1).
• Heater is defective. Replace heater.
• The solenoid valve is defective.
Replace solenoid valve.
• The handpiece cable is defective.
Replace handpiece cable.
• The micro-switch (10) of the handpiece is
defective. Pull plug and loosen screws of the
steam gun. Clean contacts. If this does not
remedy the fault, replace the micro-switch.
3. Steam escapes from the closing cover (5).
Case 1: the pressure gauge (4) displays 6 bar
or more.
• The closing cover has not been screwed on
properly. Screw tight carefully.
• The closing cover is defective.
Replace closing cover.
• The internal seal is defective. Replace seal.
Case 2: the pressure gauge (4) displays less than
6 bar.
• The pressure controller is defective.
Replace pressure controller.
6
4. The FI circuit breaker is triggered.
• Check heating, transformer, fuse and other
electronic components.
• Check device for moisture in interior and
for short circuit.
5. The device leaks.
• Check whether heating, pressure controller,
solenoid valve, copper cables and outlet screw
have been assembled correctly.
• Check whether heating, pressure controller,
solenoid valve, copper cables and outlet screw
have been sealed correctly.
12. Disposal in accordance with
EU guideline 2002/96/EU
This equipment may not be disposed in
domestic waste! Please contact the manu-
facturer or your dealer!
Registration Number Germany 3092617
Important!
FINO GmbH has prepared these instructions to help
users operate the unit and to make it easier to take
the unit into operation for the first time and then use
it. FINO GmbH cannot be held liable for damages
due to improper use or due to modifications made to
the device itself. The warranty will be voided if the
unit is used for any purpose other than its proper
intended purpose.
FINO GmbH has a policy of continuously developing
and improving its products. FINO GmbH reserves the
right to make changes or improvements to the pro-
ducts described in this document or to the document
itself without prior notice. FINO GmbH offers no gua-
rantees for the completeness or correctness of this
document.