Malongo Jo Expresso Manual Del Usuario página 17

3 - proGraMMInG the MachIne
The 2 coffee cup sizes are pre-set by default during the production phase ( 4 cl for a small cup and 6 cl for the
large cup ).
You can then change the programming as follows:
1 - Turn on the machine. All indicators will come on steady.
2 - Leave the selector in position 0 ( The indicators are still on steady ).
3 - Hold the 2 keys in for at least 5 seconds, until the green indicator starts flashing rapidly. The 2 blue
indicators will go out at the same time.
4 - Insert the pod and set the selector to the coffee position. The green LED will flash rapidly.
5 - Press the key for the required programme ( large or small cup ). The green indicator will flash rapidly and the
blue indicator on the selected key will flash slowly.
6 - Press the same key again to stop the coffee-making and save the selected cup size.
7 - Finally, bring the selector back to position 0.
iMportant
If the machine is swithed off with the selector in the coffee position:
When it is switched on:
- First of all, the green light comes on depending on the boiler temperature ( between 90 and 95 degrees ), the
it starts to flash rapidly beause it is regulating its temerature and it is impossible to make coffee during this
procedure.
- to make coffee, the selector must necessarily be returned to the position 0.
trouBleshooting
i can't maKe coffee.
Check that the green LED is on and steady. While the machine is heating, you cannot make coffee and this is
normal, check that the machine is not on standby.
tHe pods faiL to eJect
Check that the pod basket is empty.
no coffee is pourinG
Check the level of water in the tank.
tHe Led faiLs to LiGHt up
Check that the machine is plugged in. Check that the cover is fully closed.
17