Publicidad
Idiomas disponibles
Idiomas disponibles
Connections to be made
From the 7803 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Blue wire to the power antenna wire.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
• Tape off and disregard the following (3) wires with a red bullet connector,
they will not be used in this application: White/Black, White/Red, Black.
12-pin pre-wired ASWC-1 harness:
• This harness is to be used along with the optional ASWC-1 (sold separately)
to retain steering wheel audio controls. If the ASWC-1 is not being used,
disregard this harness. If it will be used, please refer to the ASWC-1
instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
®
99-7803G
Installing the interface
With the key in the off position:
1. Connect the 7803 harness into the 99-7803G, and then to the wiring harness in the vehicle.
2. Connect the factory climate control harness(es) into the 99-7803G kit.
Attention! Prior to turning the ignition on,verify that you have the harness connected
into the correct climate control port in the kit. Connecting the harness into the incorrect
port can permanently damage the kit. Refer to the picture on the following page.
3. Locate the factory antenna connector in the dash and complete all necessary
connections to the radio.
4. Before using the kit it must be programmed.
Attention! If the interface loses power for any reason, the following steps will need
to be performed again. Also, if installing an ASWC-1 connect it after you program
and test the interface/radio, with the key in the off position.
a. Start the vehicle, and then hold the rear defrost button until the LCD display starts
flashing.
b. Pay attention to the number / letter combinations during this learning sequence.
This sequence will take roughly 1 minute. Writing down all of the numbers will
help Tech Support if there is a problem.
c. After the display stops cycling through the different number / letter combinations, it
will hold on its final designation. At this point it will be programmed.
d. Turn the vehicle off, and then start the vehicle again. Test all functions of the installation
for proper operation, before reassembling the dash. The climate controls in the 99-
7803G kit will function the same way that it did with the factory climate controls.
Note: Press and hold the "Dual" button for 5 seconds to switch the temp display
between Fahrenheit and Celsius.
5. Secure the completed assembly into the dash using the (2) #10 x ¾" Phillips screws
provided, and then reassemble the dash in reverse order of disassembly.
7
Publicidad
