Connections - Metra 108-FD6CH Instrucciones De Instalación

From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
• Connect the Blue/White wire to the amp turn on wire. This wire must be connected to hear
sound from the factory amplifier.
• Connect the Orange/White wire to the illumination (lighting switch) wire
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
• Tape off and disregard the following (2) wires, they will not be used in this application:
Blue/Pink, Brown
8

CONNECTIONS

From the main harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Blue wire to the system control (Blue/White) wire.
• Disregard the Red and White RCA jacks labeled "RSE/SYNC/SAT", they will not be used
in this application.
• Disregard the Red and White RCA jacks labeled "FROM 3.5", they will not be used
in this application.
• Tape off and disregard the following (4) wires, they will not be used in this application:
Green, Green/Black, Purple, Purple/Black
Continued on the next page
|
1.800.221.0932 MetraOnline.com