Connections To Be Made - Metra 99-5838CH Instrucciones De Instalación

From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
• Tape off and disregard the following (6) wires, they will not be used in this application.
Blue/White, Brown, Green, Green/Black, Purple, Purple/Black
10

CONNECTIONS TO BE MADE

From the 5838 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Blue wire to the power antenna wire.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
• If the vehicle is equipped with SYNC, connect the Red and White RCA jacks labeled
• Disregard the Red and White RCA jacks labeled "FROM 3.5", they will not be used
"RSE/SYNC/SAT" to the audio AUX-IN jacks of the aftermarket radio.
in this application.
Continued on the next page
|
1.800.221.0932 MetraOnline.com