Delta Innovex Guia De Instalacion página 6

5
Check level left to right and front to back.
CAUTION: Shower floor and dam has a slope and
should not be used for leveling.
7
Pull unit out of framing and install drain and waste
assembly (not included). Follow manufacturer's assembly
instructions.
6
Mark unit position on all sides of framing after unit is leveled.
NOTE: These marks are used to verify shower location after
drain, waste, and overflow assembly are installed in Step 8.
NOTE: If not level, correct by shimming under base support.
CAUTION: DO NOT shim under the apron.
8
Ensure that the waste pipe is properly located to align with
the drain assembly (not included). Consult specifications
on pages 31-35 for your specific unit to ensure site
requirements are met - if you do not have specifications for
your unit, go to www.deltafaucet.com
5