Replacement Parts - Car Mate INNO XA927 Instrucciones

9
Check Safety
Caution
Make sure that all bolts and nuts are securely tighten before driving.
Always lock and secure the carrier with a key before driving.
Do not alter this product.
Attention
The lock on this rack is not guaranteed to prevent theft. For safety
reasons, do not park your vehicile for long periods of time with skis or
snowboards loaded.
Avoid drive-thru-carwash while INNO Carriers are mounted on the roof .
Use caution when handling ski or snowboard around the tailgate and or
truck lid area.
80 130
mph ( km/h)
10
How to store
Remove carrying system from vehicle when not in use.
Store Carrier in a dry and dark place.

Replacement parts

Replacement parts are available from Make. Contact
sales shop where you purchased the carrying system.
Specifications are subject to change without prior
notice.
ISP 869
3 4 5
Contact Information
If you have any comments or suggestions, please contact our service center listed. CAR MATE USA
shall not be held liable for any accidents or incidental losses arising from improper installation or
use, nor for those arising from installation or use after the customer has made any change to the
system's original configuration or specifications.
Caution
Safe driving
Avoid hard acceleration & sharp
turns. Reduce speed under high
winds and rough road condition.
50 80
mph (
or less
Binding
ISP 870
6 7 2
x 4
Caution
km/h) or less
Driving at a speed less than 80 mph (130 km/h)
Crossbar
Do not exceed a speed of 80 mph (130 km/h) when carrying
ski or snowboard. And observe legal speed limit.
If the bindings do not fit between the front and rear crossbars,
move the snowboard so that one of the bindings is on the
front side of the front carrier, and make sure you do not
exceed 50 mph (80 km/h) when driving.
Rubber cusion
x 4
- 3 -
Caution
Do not use ski / snowboard
case
Avoid using ski / snowboard covers,
due to high winds and pressure may
cause the Ski and snowboard to
come off from the carrier.
Caution
Do not use any lubricate on the key and
bolts.
Do not use thinner and solvent as they may
damage the plastics.
Rubber cusion
CAR MATE USA, Inc.
383 Van Ness Ave., Suite 1603
Torrance, CA 90501 U.S.A.
support@innoracks.com
www.innoracks.com
Key
Verify the key
number
Instruction