Installation; Antenna Setup; Motor Setup - Galaxy Innovations ST9195 Manual Del Usuario

2. Installation

2.1 Antenna setup

2.2 Motor Setup

Note
Setting DiseqC 1.2
1. Select DiseqC 1.2 in the Motor setup menu.
2. Select satellite.
3. Move motor until you see good signal.
4. After searching satellite, SAVE current position.
5. Repeat this operation for other satellites.
6. Go to Auto search menu with RED key.
Setting USALS
1. Select USALS in the Motor setup menu
2. Enter longitude and latitude value
3. Save current setting in move control
4. Move motor to current satellite position and
check signal.
5. Go to Auto search menu with RED key
MANUAL_GI ST9195_9196_Eng_091127.indd 11
 Satellite :
Select any satellite by pressing  keys.
(Press blue key to edit the name of the satellite)
 Transponder : Select a transponder.
 LNB Type :
Dual / Universal, Single, OCS, Wideband, Digiturk
MDU1, Digiturk MDU2.
 LNB Frequency : Select a proper LNB frequency.
(Press blue key to input local frequency)
 UNICABLE : Select a unicable channel
 DiSEqC 1.0 & 1.1 : Select between "None" or "DiSEqC1.0 A, B, C, D " and "
DiSEqC1.1 1 ~ 16".
 Polarity Control : Select one out of "14/18V", "0/12V", "0/22KHz".
 0/12V Switch :
Select between "OV", and "12V".
 0/22KHz Switch :
Select between "0KHz", "22KHz", "Auto".
Note
Make sure to save searched channels before exit.
Press YELLOW button to initialize satellite value.
After Antenna setup, you can move to Auto search menu with RED button.
You can Select "None", "DiSEqC1.2", or "USALS" by pressing  keys.
 Motor Type : Select a motor type by pressing  keys.
(Press blue key to edit the name of the satellite)
 Satellite :
Select a Satellite.
 Transponder : Select a transponder.
2.2.1 Setting up DiSEqC1.2
In the Motor Setup Menu, select the DiSEqC1.2 then the following menu will be
displayed.
 Satellite : Select a satellite by pressing  keys.
(Press blue key to edit the name of the satellite.)
 Transponder :
Displaying current TP value.
 Nudge Size : Motor move step (1-5).
 Move Coarse :
Move west ( key), Move east( key).
 Move Fine :
Move by the value of Nudge size.
 Motor Contro l :
GOTO, SAVE, GOTOREF.
 Limit Setup :
Setting limit.
- EAST LIMIT : Confirming the setting of East Limit.
- WEST LIMIT : Confirming the setting of West Limit.
- DELETE LIMIT : Delete the setting of East & West Limits.
11
2009-11-28 1:59:49