General Safety Information - BONAIRE Durango 350 Manual Del Propietário

1. General Safety Information

Thank you for purchasing a quality Bonaire Evaporative Portable Cooler. We care about your
safety and would ask you to spend a few minutes reading these simple instructions before
operating this product.
Safety!
Read carefully prior to attempting to assemble, install, operate or maintain the
unit.
Read and save these instructions. Do not throw these instructions away
-
Complete the unit assembly before attempting to operate.
-
Interference with and operation of this cooler in any manner not prescribed by these
-
instructions could cause a safety issue and WILL void any warranty.
WARNING:
Do not use cooler on uneven or unstable surfaces.
-
Lock all the lockable wheels before operating cooler.
-
Do not overfill. Use water only.
-
- Do not operate cooler with Rear Filter Panel removed.
Do not insert any foreign objects or body parts into the air inlet or outlet, otherwise
-
bodily injury or property damage may occur.
- Do not use immediately adjacent to heat sources such as stoves or radiators.
Do not use immediately adjacent to sources of water, such as swimming pools, hot tubs,
-
bathtubs, showers, sinks or other liquids.
- Do not operate this product near an open flame or the product may ignite and cause fire,
resulting in bodily injury or property damage.
Do not operate in areas where gasoline, paint or other flammable liquids or vapours are
-
used or stored.
WARNING:
All electrical connections must comply with local construction and safety regulations
-
and be performed by qualified personnel.
The power cord should be connected directly to a
-
grounded GFCI protected electrical receptacle.
the off position before connecting and operating your cooler.
Do not use this product with any solid- state speed control device.
-
- Keep the cord away from heated surfaces.
- Do not operate cooler with a damaged cord, plug or other components.
Do not step on or roll over the power cord with heavy or sharp objects.
-
Do not run the power cord under carpet or other floor covering. Arrange cord away from
-
traffic area and where it will not be tripped over.
120VAC +/-10%, 60 Hz, 1 phase only
Make sure that the power switches are in
3