BONAIRE Durango 350 Manual Del Propietário página 6

5. Electrical Connection and Installation
Review and understand the warnings in the General Safety Information section, page 2
& 3.
1. Front Wheel Installation:
Insert the small wheels with brake into the
round hole at the front of bottom.
2. Back Wheel Installation:
a. 350: Insert the big wheels into the slot at
the back of bottom.
(Insert the small end first, the big end should
align to be flat with the slot opening.)
b. 600 & 800: Insert the small wheels with no brake into the round hole at the back of
bottom.
3. Install the cooler on a flat, level surface. Depress locking levers on the two front wheels to
prevent movement.
4. Adjustable Up and Down louvre: Open the air shutter
before turning on the unit, using the two protruding
handles. Adjust the louvers up and down manually to
a comfortable direction.
5. Add clean water into the water tank. Check the water
level window on the right hand side of the cooler to
see when the water tank is full.
6. Plug the unit into a 120 VAC ( 10%) 60 Hz, 1 phase GFCI protected grounded outlet.
6. Operation
Control Panel & Remote Control
1. ON/OFF: Push this button to start the air cooler, you will hear a short "Beep". Meanwhile,
cooling and swing functions are turned on automatically. Cooler starts with high speed air flow.
To turn off the air cooler, push the "ON/OFF" button.
2. COOL: The cool function begins automatically after turning on the air cooler, when the unit
has enough water. Push the button to switch to fan-only mode. Press it once more to turn cool
function on again. The indicator light will turn on during cool mode.
3. SWING L/R: This function is started immediately after turning on the unit, and is indicated by
the SWING L/R indicator light being on. Under this condition, the air flow slowly sways from left
to right. To stop this function, push this button once more. The indicator light will also turn off.
Pushing it once more will start the swaying of wind board once again.
6