Candy CCVB 30/1 Instrucciones De Instalación página 9

 Temperature Recollection Function
In the event of a power interruption, wine chiller can remember the previous temperature settings,
and when the power is recovery, the cooler temperature will go back the same setting temperature
as power off.
 Internal light
In order to reduce energy consumption, this wine cabinet will automatically switch off the LED lights
after 10 minutes.
If you want the LED light to remain on continuously, this is possible. Please press and hold the
"LIGHT" button for 5 seconds, the display will show "LP".After 4 seconds the display will revert back
to normal and the light will remain on until manually switched off.
If you want to revert back and conserve energy (recommended), please press and hold the "LIGHT"
button for 5 second, the display will show "LF",after 4 seconds the display will revert back to normal,
and the light will automatically switch off after 10 minutes.
 Shelves
To prevent damaging the door gasket, make sure to have the door all the way opened when
•
pulling shelves out of the rail compartment.
For easy access to the storage content, you must pull the shelves approximately 1/3 out of the
•
rail compartment, however this unit was designed with a notch on each sides of the shelf tracks
to prevent bottles from falling.
When removing any of these shelves out of the rail compartment, To fit or remove the shelf, tilt
•
the shelf as per the diagram and simply pull out, or push in the shelf until it sits on the support
brackets securely.
NOTE:

• If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the Wine cooler/beverage cooler will
not start.
• When you use the Wine cooler/beverage cooler for the first time or restart the Wine
cooler/beverage cooler after having been shut off for a long time, there could be a few degrees
variance between the temperature you select and the one indicated on the LED readout. This is
normal and it is due to the length of the activation time. Once the Wine cooler/beverage cooler
is running for a few hours everything will be back to normal.
8