Publicidad
Installation Instructions for AXBUCS-NI246V
Connections to be made
• Connect the Black wire with a ring terminal to chassis ground.
• Connect the Black wire of the AXCSD-6V wire to chassis ground.
• Connect the Red wire labeled "Camera Power 6V" to the Blue/Red wire
of the AXCSD-6V.
• Connect the Green/Purple wire to the reverse wire of the aftermarket radio,
and also to the Blue/White wire of the AXCSD-6V.
• For all models except the Cube / Rogue, if retaining the factory AUX-IN jack,
connect the Red & White RCA jacks to the AUX input.
• Connect the Yellow RCA jack to the rear camera input of the aftermarket radio.
12-pin pre-wired AXSWC harness:
This harness is to be used along with the optional AXSWC (not included) to
retain steering wheel audio controls. Please refer to the AXSWC instructions
for radio connections and programming.
Note: Disregard the harness that comes with the AXSWC.
• Connect the unlabeled Red wire to the accessory wire.
Axxess Integrate
REV. 5/19/20
K
P
NOWLEDGE IS
OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
axxessinterfaces.com • metraonline.com
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
Metra recommends MECP
certified technicians
Publicidad
