Maintenance And Technical Information - Campbell Hausfeld PW2725 Manual Del Usuario

Operation (Continued)
never pull the
starter rope on
the engine when the spark plug is
removed unless the spark plug hole
is covered. Fuel vapor from the
hole can ignite by a spark.
7 . Place a rag over the spark plug hole
and slowly pull the starter rope
several times to distribute the oil .
WINterIzING INStruCtIONS
1 . Follow and complete the Long Term
Storage Instructions above .
2 . Disconnect the spark plug wire .
3 . Disconnect the high pressure hose
from the pump .
4 . Insert a 12 in . to 14 in . piece of
garden hose into the pump inlet .
Maintenance
Observe regular maintenance intervals
to ensure maximum performance and
life from the pressure washer . Refer
to the schedule for recommended
maintenance . If you operate the
pressure washer in dusty conditions,
perform maintenance checks more
often .
eNGINe OIl ChANGING
INStruCtIONS
before tipping
the engine or
equipment to drain oil, drain fuel from
the fuel tank.
NOte: Change oil while the engine is
cool .
5 . Place a funnel in the other end of
the garden hose .
read the
manufacturer's
instructions for safe handling and
disposal of rV antifreeze.
6. Pour approximately 6 oz. of RV
antifreeze into the funnel .
7 . Pull the starter rope several times
until the RV antifreeze comes out of
the pump outlet .
8 . Disconnect the high pressure hose
from the gun and drain the hose .
Hold the gun and lance in a vertical
position and squeeze the trigger to
drain the water out .
1 . Disconnect the spark plug wire from
the spark plug .
2 . Locate and remove the engine oil
drain plug (See Figure 15) .
O F
il ill
Oil Drain
Figure 15 - Oil drain and fill locations
9
PW2725, PW3230, PW4035
tIPS FOr exteNDING the lIFe OF
YOur PreSSure WASher
1 . Never operate the unit without
water .
2 . Your pressure washer is not meant
to pump hot water . Never connect
your pressure washer to a hot water
supply as it will significantly reduce
the life of the pump .
3 . Running the unit for more than
one minute without spraying water
causes heat to build up in the
pump . Running the unit without
spraying water can damage pump
components .
3 . Drain old oil .
4 . Replace the drain plug and set the
unit upright .
5 . Refill the unit with new oil of a
recommended type and quantity . Fill
the unit to the bottom edge of the
oil fill neck .
PuMP OIl CheCKING/ ChANGING
INStruCtIONS
Please refer to provided AR Pump
Specification page provided with your
Pressure Washer for details .
www.chpower.com