Canopy Assembly; Blade Assembly - Craftmade Ellington BEL52BNK3-NRG Manual Del Usuario

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both screws
securely. Slide canopy cover up to canopy,
aligning rounded part of slotted holes in
canopy cover with screwheads in bottom of
canopy. Turn canopy cover to the right
(clockwise) until it stops.

8. Blade Assembly.

Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 9 blade attachment screws and washers
and 9 decorative nuts in one of the hardware
packs. Place blade arm on TOPSIDE of blade,
aligning holes in blade arm with holes in blade
as shown. Insert 3 decoratvie nuts into holes
from UNDERSIDE of blade (i.e., the side that will
face the floor), making sure to completely insert
each decorative nut so that the blade arm can be
attached correctly. Insert 3 blade attachment
screws (along with washers) from TOPSIDE of
blade with fingers first and then tighten screws
securely with Phillips screwdriver. Repeat
procedure for remaining blades.
Remove blade arm screws and lock washers from
fan motor and set aside. [WARNING: Do NOT
remove the 4 screws located on the outer rim of
the underside of the motor housing--doing so or
any attempt at doing so will void the warranty.]
Locate label indicating THIS SIDE UP on one of
the blade arms. Align blade arm holes with
motor screw holes and attach blade arm with
lock washers and blade arm screws. Before
securing screws completely, repeat this
procedure with remaining blade arms. Once all
blade arms have been attached, secure all screws
in all blade arms.
Note: Tighten blade arm screws twice a year.
screw
canopy cover
THIS SIDE UP
lock washers and
blade arm screws
page 6
hanging
bracket
canopy
screw
motor
housing
blade attachment
screws and washers
blade arm
blade
decorative
nuts