bebeduE MAGIC Manual Del Usuario página 49

UK
IMPORTANT: PLEASE READ THESE INSTRUCTIONS FOR
USE CAREFULLY AND SAVE THEM FOR FUTURE
REFERENCE.
Thank you for depositing your trust in Bebé Due products.
GROUP 0+ SAFETY CAR SEAT
For children up to 13 kg in weight
ATTENTION
1. This baby car seat is universal and approved by Regulation ECE 44.04 for its general use
in vehicles, therefore, it can be installed in the seats of most cars, although not in all.
2. It will be possible to adequately install the car seat if the manufacturer of the vehicle outlines
in its vehicle use manual that the vehicle accepts universal type car seat for this group.
3. This baby car seat is universal and complies with regulations that are stricter than those
applied to prior designs that are not classi ed as universal.
4. In case of doubt please consult with the manufacturer of the safety baby car seat or with
your supplier.
This seat can only be installed in vehicles with 3 static points, 3 retractable points, approved
by UN/ECE regulation number 16 or other equivalent standards.
EXTREME DANGER
Never use this baby car seats in passenger seats equipped with front airbags (SRS).
MANDATORY SAFETY BELT IN AUTOMOBILE (Fig. 1)
"WARNING: the baby car seat must never be placed in a seat with front airbags
(SRS)."
The baby car seat can only be installed with a diagonal belt and three-point seat belt on the front
or back seat of the car.
HOW TO INSTALL GROUP 0+ IN THE AUTOMOBILE (Fig.2)
A. Place group 0+ in a passenger seat with a three-point belt and place it looking in the opposite
bearing to the direction. The transport handle must be in the 1st position.
B. Pass the diagonal belt through the slot located on the backrest and then anchor the safety
belt, checking that the belt has not become tangled.
C. Pass the belt through the slots located on the lateral sides of group 0+.
D. Finally pull on the safety belt until group 0+ is perfectly attached to the seat of the car.