Check the parts of group 0+ on a regular basis.
Inspect the joints, xing devices, straps and carrying handles... to insure that they are safe and
comply with their operation.
Always store group 0+ in a dry and safe place.
WARNINGS
If these warnings and assembly instructions are not followed, the
result could be serious injuries.
"WARNING – Leaving a child unsupervised may be dangerous".
· Never install group 0+ in a seat with a front AIRBAG system.
· Never place the baby in group 0+ without buckling-up the harness.
· Never use anything (cushion, clothing, etc.) to raise group 0+ in the
seat, as in case of accident it would not serve its purpose correctly.
· Never try to dismantle, modify or add any part to group 0+.
· Never surpass the weight for which group 0+ is approved, 13 kg.
· Never place group 0+ on an elevated surface, tables, beds, etc.
· Never leave group 0+ in the automobile without rst anchoring it,
even when it is not in use.
· Never leave the baby in group 0+ unattended.
· Never install group 0+ in seats that are positioned in the direction of
the window.
· No car chair is escape-proof: anchoring systems cannot be fully
designed in due
R44/04 to insure that the baby will not try to unbuckle the chair.
The harness must be unbuckled and correctly
you place your baby in the chair and you must try to persuade the
child to not unbuckle the chair.
· Always exchange group 0+ for a new one after an accident.
· Be careful that no part of group 0+ is damaged or crushed when
reclining the car seats or that it is not touching the doors of the car.
· Be extremely careful when installing group 0+, given that correct
installation can save your baby's life in the case of an accident.
· Group 0+ guaranties the safety of the mechanisms when it is used
by a rst purchaser. Never use second-hand articles when safety is
an issue.
· It is important that all passengers wear safety belts and that the car
load (suitcases, etc.) be duly secured, as in case of accident they may
be ejected from their seats and injure the baby.
· The harness corresponding to group 0+ must never be used without
its protection.
compliance with the legal European standard ECE
adjusted each time
UK