bebeduE MAGIC Manual Del Usuario página 51

UK
INSTALLATION OF GROUP 0+ IN THE CHAIR (Fig. 10)
Once you have located the chair's anchors, which are found on the armrests, place group 0+ on
top of the chair, where it will be centered so that the chair's anchors can coincide with those of
group 0+. Anchor group 0+ to the chair, checking that both anchors have made a clicking sound.
You can then check that it is correctly anchored by lifting group 0+, and if installation is correct it
will also be possible to lift the chair.
DISMANTLING OF GROUP 0+ IN THE CHAIR (Fig. 11)
Lift the levers located on the anchors of group 0+ and pull upwards on group 0+ at the same
time, which will liberate the mechanism.
IMPORTANT: always execute this operation when the baby is not sitting in group 0+.
To use the chair without group 0+, replace the lining on the armrests and adjust the backrest to a
sitting position.
HOW TO REMOVE THE LINING FROM GROUP 0+ FOR ITS CLEANING (Fig.12)
A. Dismantle the canopy by placing the transport handle in position no. 5 (please see g. 3).
Move the canopy forward until the hooks on the rod are in-line with the anchors, then pull
outwards from the rod.
B. Unbuckle the harness to remove the protections from the shoulder straps and reducer.
C. Remove the crotch buckle. To remove the buckle rst nd the metallic connector that holds
the buckle strap in the bottom part of group 0+. Then pull outwards on the connector and
remove the strap from the connector.
D. Pull upwards on the buckle and remove the protector.
E. Unhook the lateral clips from the lining.
F. Remove the upper and lower part of the lining by pulling forward and it will be liberated. To
replace the lining, follow the same steps in inverse order.
RECOMMENDATIONS FOR CLEANING
Hand wash in warm water with detergent for delicate garments. Do not use chemical detergents
and never use bleach or dye the fabric.
Allow the lining to dry out in the shade.
Plastic parts and painted parts must be cleaned with water and a mild detergent. Never use
abrasive detergents.
Always check the label for cleaning instructions.
MAINTENANCE
Group 0+, in like manner to other dynamic products, requires regular attention to avoid any
service problems.
Always use temperature protectors (safety chair solar protector) when you park your vehicle in
the sun.
Never leave group 0+ exposed to direct sunlight during long periods of time, as the fabric and
plastic parts may su er deterioration.