Sound-Active Mode - TECshow Quatrobeam Move Manual De Usuario

1. Auto running
When the display shows "AUTO", the light will run as the
program which had been set. Press "SETUP" button to
enter into the optional menu. Press "UP" and DOWN" to
choose the optional which need to set the parameter as
below: Led, Pan or Tilt.
•
LED function
1. When choose "Led", and press "SETUP"
enter to LED auto running parameter setting.
The option with black marks is selected. You
could choose "Auto", "Color" or "Dimmer".
When choose "Auto", press "SETUP" button
enter to setup menu.
Press "UP" and "DOWN" to select the param-
eter. When choose "Speed", press "SETUP" to
choose the speed menu of the auto running.
Press "UP" and "DOWN" to adjust the auto
running speed from 01-20.
When choose "Freq.", press "SETUP" to set
the flash speed.
Press "UP" and "DOWN" to adjust the flash
speed 00-20Hz.
2. When choose "Color", press the "SETUP" to
set the parameter. Choose "Static" and press
"SETUP" again to enter color program. Press
"UP" and "DOWN" to choose relative color.
3. When choose "Dimmer", press the "SET-
UP" to set the parameter. When choose
"RED", "GREEN", "BLUE" or "WHITE",
press "SETUP" to enter relative gray level:
0-255. When choose "Freq. ", press "UP" and
"DOWN" to set the flash speed 00-20Hz.
•
Pan function
•
When choose "Pan", press "SETUP"
enter the functzion choose menu. Pan has 4
modes, p-Auto, p-Manul, p-CW and p-CCW.
1. When choose "p-Auto", pan enters to
build-in program.
2. When choose "p-Manul", pan stops in set-
ting location. Press "SETUP" enters to set pan
location. Press "UP" and "DOWN" to adjust
the location: 0—540 degrees.
3. When choose "p-CW", Pan turns with
clockwise direction (from the LED light). Press
"SETUP", enter to set Pan speed setting. Press
"UP" and "DOWN" to adjust the speed: 1-16.
4. When choose "p-CCW", Pan turns with
anti-clockwise direction (from the LED light).
Press "SETUP", enter to set Pan speed set-
ting. Press "UP" and "DOWN" to adjust the
speed: 1-16.
•
Tilt function
1. When choose "Tilt", press "SETUP" enter
the function choose menu.
2. Pan has 2 modes, t-Auto and p-Manul.
3. When choose "t-Auto", Tilt enters to
build-in program.
4. When choose "t-Manul", Tilt stops in set-
ting location. Press "SETUP" enters to set tilt
location. Press "UP" and "DOWN" to adjust
the location: 0—200 degrees.
2. Build-in program
When display shows "SHOW", it enter to the build-in program.
Press "SETUP" to enter the build-in programs. There are
9 programs inside. Press "UP" and "DOWN" to choose
the built-in program from Show1 –Show9 (the built-in
program is pre-set and can't be reset).

3. Sound-active Mode

When display shows "SOUND", enter the sound-active mode.
Press "SETUP" enters the menu of adjusting the sound
sensitivity. Press "UP" and "DOWN" to adjust the sensi-
tive value from 0-31.
P. 6
QUATROBEAM MOVE
ENGLISH VERSION