Inspection And Adjustment; Tubular Vial - Prexiso T.O.2 Manual Del Usuario

5 Inspection and Adjustment

5.1 Tubular Vial

Inspection
Adjustment
Inspection and Adjustment
1. Fix the instrument to the tripod and roughly level up the instrument and make the
tubular vial parallel to the connecting line of two of the three leveling screws on the
base. Adjust the two leveling screws so that the tubular vial is centered.
2. Turn the instrument 180° and check if the water bubble remains at the center.
3. If the water bubble remains at the center, no adjustment is required; otherwise,
perform adjustment as follows.
1. Adjust the bubble adjusting screw so
that the bubble moves toward tube
center for half the off-center.
2. Turn the leveling screw to correct the
other half off-center so that the bubble
stays at the center.
3. Repeat the steps in "Inspection" and
"Adjustment" until the long water level is
centered when the instrument is at any
position.
T.O.2 | 30