drip onto other food.
- Two-star frozen food compartments
are suitable for storing pre-frozen
food, storing or making ice cream and
ice cubes.
- Do not freeze fresh food in one, two or
three-star compartments.
- If the refrigerating appliance is left
empty for long periods, switch off,
defrost, clean, dry, and leave the door
open to prevent mould developing
inside the appliance.
INSTALLATION
The appliance must be handled
and installed by two or more persons -
risk of injury. Use protective gloves to
unpack and install - risk of cuts.
Installation, including water supply
(if any), electrical connections and
repairs must be carried out by a
qualified technician. Do not repair
or replace any part of the appliance
unless specifically stated in the user
manual. Keep children away from the
installation site. After unpacking the
appliance, make sure that it has not
been damaged during transport. In the
event of problems, contact the dealer
or your nearest Aftersales Service.
Once installed, packaging waste
(plastic, styrofoam parts etc.) must be
stored out of reach of children - risk
of suffocation. The appliance must be
disconnected from the power supply
before any installation operation - risk
of electric shock.
During installation, make sure the
appliance does not damage the power
cable - risk of fire or electric shock.
Only activate the appliance when the
installation has been completed.
Be careful not to damage the
floors (e.g. parquet) when moving the
appliance. Install the appliance on
a floor or support strong enough to
take its weight and in a place suitable
for its size and use. Make sure the
appliance is not near a heat source
and that the four feet are stable and
resting on the floor, adjusting them as
required, and check that the appliance
is perfectly level using a spirit level.
Wait at least two hours before switching
the appliance on, to ensure that the
refrigerant circuit is fully efficient.
To guarantee adequate ventilation,
leave a space on both sides and above
the appliance. The distance between
the rear of the appliance and the wall
behind the appliance should be 50
mm, to avoid access to hot surfaces. A
reduction of this space will increase the
Energy consumption of product.
WARNING: When positioning the
appliance, ensure the supply cord is not
trapped or damaged.
WARNING: To avoid a hazard due
to instability, positioning or fixing of the
appliance must be done in accordance
with the manufacturer instructions. It's
forbidden to place the freezer in such
way that the metal hose of gas stove,
metal gas or water pipes, or electrical
wires are in contact with the freezer
back wall (condenser coil).
ELECTRICAL WARNINGS
It must be possible to disconnect
the appliance from the power supply by
unplugging it if plug is accessible, or by
a multi-pole switch installed upstream
of the socket in accordance with the
wiring rules and the appliance must
be earthed in conformity with national
electrical safety standards.
Do not use extension leads, multiple
sockets or adapters. The electrical
components must not be accessible
to the user after installation. Do not
use the appliance when you are wet or
barefoot.
Do not operate this appliance if it has
a damaged power cable or plug, if it is
EN - 38