Inspection And Maintenance; Cleaning And Storage - Honeywell NORTH FP02 Serie Manual De Instruccion

4.0 Inspection and Maintenance

Inspection
Anchor Slings must be visually inspected by the user before each use and inspected by a
Competent Person (other than the user) on a regular basis, at least annually.
Inspect product for any of the following:
• absence of or alteration to any elements affecting the equipment form, fit or function
• bent, cracked, distorted, worn, malfunctioning or damaged parts;
• loose fasteners or missing parts/components;
• evidence of defects in or damage to webbing and wire rope*
• evidence of defects in or damage to hardware components, such as deformation,
cracks, breaks, corrosion, pitted surfaces, chemical attack, and rough or sharp
edges
• deterioration or excessive wear;
• absence or illegibility of markings/labels;
• signs that indicate the product has been subjected to fall arrest forces;
• or any other indications of damage/problems that may affect the integrity and
operation of the product.
If in doubt, contact the manufacturer.
*When inspecting webbing, wire rope or other materials/fibers used in the construction of
the anchorage connector, be sure to inspect each section, rotating and flexing, to reveal
any damage, cuts, broken strands/fibers, frayed areas, pulled stitches, burns, chemical
damage, unusual wearing patterns, or signs of deterioration.
*CAUTION: Always wear gloves when inspecting wire rope; broken
strands can cause injury!
or have been subjected to fall arresting forces

Cleaning and Storage

Clean anchor slings periodically with a sponge dampened in a mild solution of water and com-
mercial soap or detergent to remove any dirt, paint, contaminants, or other materials that may
have accumulated. Wipe with a clean cloth and hang freely to dry away from excessive heat,
steam, or long periods of sunlight. When not in use, store in a cool, clean, dry area, away from
chemicals, fumes, water, corrosive or degrading elements, ultraviolet light, and sources of heat
or sparks. Store hanging loosely, free of kinks and knots.
Servicing
Servicing of North equipment must only be carried out by Honeywell Safety Products or persons
or entities authorized in writing by Honeywell. A record log of all servicing and inspection dates
for this device must be maintained. Only original North replacement parts are approved for use
in this device. Non-repairable devices that do not pass inspection must be disposed of in a man-
ner to prevent inadvertent further use. Contact Honeywell Technical Service at 800.873.5242
(press 4) if you have any questions.
Us er Ins tru ct ion s - Engl is h
Devices that do not pass inspection
must be removed from service.
12