NXS Mobile Audio NXLCDC Instrucciones De Instalación página 9

X
-OVER ADJUSTMENTS (2 & 4 CHANNEL AMPLIFIERS)
Selection
Indicator
When in the X-over channel mode, rotate the selection knob and the position indicator ( ) will show your
location on the LCD screen. Select the *channels you wish to adjust and press the center of the control
knob to adjust selected channels. Next rotate the selection knob to the X-over type you wish to use ( i.e.
Low Pass (HP), Low Pass (LP) or Bandpass (BP)). Once the position indicator is on desired crossover
type, press the center of the selection knob to select and the display will show a check mark ( ) and "ON"
will be displayed indicating the selection you have made is active.
Select the *channels you wish to
adjust and press the center of the
control knob.
HIGH PASS SETTING
20Hz
*NX400.4 selections shown, LCD screen shots will look different however the overall x-over function remains the same.
1 2
3 4
PC INPUT
NXLCDC
Position Indicator shows your
location on the LCD screen.
X-Over Examples
LOW PASS SETTING
20Hz
20kHz
Once the amplifier selection has been loaded, rotate the
selection knob until the selection indicator points to "X-
OVER" and press the center of the selection knob once
to enter the x-over channel mode.
20kHz
8
This example shows High Pass
(HP) is selected and the text "ON"
is displayed.
BAND PASS SETTING
20Hz
20kHz