General Information - Simeon sprek Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

General Information

Digital
Transmitter
Boom Mic
(Headset
Microphone)
Gooseneck
Microphone
Speaker
Connections
Bluetooth
Charge fully before first use using the charging adapter and USB cable provided.
The digital transmitter is supplied with a gooseneck and a boom (headset)
microphone.
In most circumstances the boom (headset) microphone will offer the best
performance. The gooseneck microphone offers convenience and must be
positioned within 20cm of the mouth to perform well.
Avoid pointing the microphone directly at the speaker or feedback (squealing sound)
may occur when you turn the system on. Select a low volume level initially and
slowly increase the volume to a comfortable listening level.
If you chose to use the headset microphone plugged directly into the speaker (see
below for 'hard-wired' operation) make sure the digital transmitter is turned OFF.
The boom microphone picks up speech close to the mouth, improving performance
in noisy environments, and will help to avoid any acoustic feedback.
Place the mic frame earhooks over your ears and adjust the boom arm to position
the mic capsule to point to the corner of your mouth.
It is not necessary to place the microphone in front of your lips and doing so may
diminish sound quality.
The boom microphone frame can be adjusted to rest comfortably over both ears,
with no other contact or pressure points against the head or face.
Plug the microphone into the jack on top of the digital transmitter
Alternatively, the boom microphone may be plugged directly into the AUX IN port
of the speaker for 'hard-wired' operation. In this mode of operation the digital
transmitter should be turned OFF.
The gooseneck microphone may be used if the digital transmitter is worn around
the neck on the lanyard supplied with the system.
Position the microphone so the capsule is within 20cm from your mouth. Adjust the
flexible gooseneck away from your body so that the microphone windscreen does
not rub against your clothing.
Plug the microphone into the jack on top of the digital transmitter.
It is not recommended to plug the gooseneck microphone directly into the speaker.
Use the charging adapter and USB cable provided with the Sprek speaker.
The speaker has an AUX IN port which will accept most Simeon microphones as
well as peripheral audio devices.
The AUX IN port does not support consumer smartphone earphones or headsets.
Note that the digital transmitter communicates with the speaker via a 900MHz real-
time wireless signal. The Bluetooth function is used only for streaming audio from
smartphones and other devices.
When pairing your smartphone or other Bluetooth device with the speaker to
stream music etc., keep them less than 10m apart.
3

Publicidad

Tabla de contenido
loading

Productos relacionados para Simeon sprek

Tabla de contenido