Operating The System - Simeon Audita II Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating the system

Using the Audita II portable receiver / speaker
Check the position of the two volume controls [3] on front of the receiver. There are
two independent volume controls - one for each transmitter. If you are using your
system for the first time, set at a low volume level before turning the system on. Turn
the receiver ON at the master power switch on the front of the speaker [1]. A green
light indicates that the receiver is on and ready to use.
Your Audita II is delivered with channels already assigned and the system is ready to
use. The pre-assigned channels should not usually need to be changed. However, it
is important that separate channels are selected for each system that is used in the
same location.
With the Audita II
digital
system, the transmitters will pair automatically to the
channel group selected on the receiver. With Audita II FM, channels are manually
selected, with a separate channel assigned to each of the transmitters.
Using the pendant transmitter
To turn the pendant transmitter ON, press the power button [17] for 2 seconds.
The display will show the transmitter channel selection and the battery status.
By pressing the power button briefly, you can conveniently mute / unmute the
transmitter. The power button will be lit by a blue indicator when the transmitter
is in TALK mode, and by a red indicator when the transmitter is muted. To turn the
transmitter OFF, press and hold the power button for 2 seconds.
The pendant transmitter has a built-in directional microphone [11]. When wearing
the transmitter around your neck, adjust the lanyard length so that the pendant
microphone is in the best position to pick up your voice - usually about
20cm
below
the mouth. If you would prefer to wear the transmitter at waist level, you will need
to use the 625 boom (headset) accessory microphone supplied with your system.
The pendant transmitter has a microphone input jack [12] for connecting the
boom mic. Note that there is also an auxiliary input jack [13], which is used only for
connecting to external audio devices to the transmitter.
As an alternative to using the transmitter charging cradle, the pendant transmitter
can be charged directly by plugging the charging adapter into the charging jack [18].
Use only the recommended charging adapter for direct charging of the pendant
transmitter.
7

Publicidad

Tabla de contenido
loading

Productos relacionados para Simeon Audita II

Tabla de contenido