Elvox Due Fili 692S Manual Para El Conexionado Y El Uso página 3

Idiomas disponibles

The separator device is an accessory used in 2-WIRE ELVOX systems to create separate communications islands and it is used together

with the type 6922 power supply. It should be used in the following cases:

- In building complex type installations where there is one or more main entrance panels, one or more buildings with 'one or more secon-

dary panels inside. One separator for each building.

- In installations where panels are connected to an interphone or to a video entry system outside. One separator for each panel outside.

- In installations where interphones and video entry systems are connected, that should not engage the lines of the other devices while

speaking.

Terminals and jumpers

1, 2 (BUS_P)

Main bus line, to the main panel or branch of the installation.

1, 2 (BUS_D)

Secondary bus line, to the interphones/video entry systems or isolated branch of the installation.

A, B, C, D

Establishing video signal

0, 1, 2, 3 ID

programming.

It is possible to connect up to a maximum of 16 separators in the same installation. It is necessary to associate an ID code different to them

by using the 0, 1, 2, 3 jumpers.

IDENTIFICATION

Jumper not inserted

Jumper inserted

0 1 2 3

Indicators

In the separator there are two pairs of LED lights (red and green) in the horizontal card, and one LED for each card in the vertical cards.

LED 1 on

means the main bus is powered.

LED 2 on

means the secondary bus is powered.

TXD and RXD

communication underway on main bus

TXP and RXP

communication underway on secondary bus

Note: if no calls have been made or no services enabled (open lock, enablers, etc.) in the installation, the TXD, RXD, TXP, RXP LEDs should

remain off.

ESTABLISHING A VIDEO SIGNAL inside the separator there is a connector and a jumper to establish the video signal (see Fig. 1A). This

jumper should be used in video installations to establish the video signal. When the separator is within a bus line, the terminals of the main

line are used as input-output, the jumper should be placed between point A-B. If the separator is at the end of the bus line, the terminals of

the main line are used only as input, the jumper should be placed between B-C or C-D to obtain the best results for the video signal.

Press to return to index

D E S C R I P T I O N

0 1 2 3

Fig. 1