Wiseup WIFI 25 Manual Del Usuario página 3

4.2. P2P or LAN Mode Setup
4.2.1. Slide the power switch to the position next to the reset button to power on the camera. The
red indicator light will illuminate for 3 seconds and then go out. The blue indicator light will stay
illuminated. 15 seconds later, the red indicator light will start flashing slowly, indicating the camera
has entered into the P2P mode.
4.2.2. Go to Wi-Fi Settings page on your smartphone or tablet PC, and connect to the camera's
Wi-Fi signal. The Wi-Fi signal name starts with "CM***********" and it will appear on your Wi-Fi
setting page as follows:
(Android) (iOS)
[Note]:
1).
It will take 1-3 minutes before the Wi-Fi signal appears on you smartphone or tablet PC.
2). If the camera Wi-Fi signal cannot be found on your smartphone or tablet PC, reset the camera, and then try it
again.
3). If the battery is low, the red indicator light will not turn on. Please recharge the camera before using.
Q: How to reset the camera?
A: When the red indicator light is turned on, hold the Reset Button for 2 seconds to reset the camera.