Operation Test - Optex REDWALL V Serie Instrucciones De Instalación

9-2 Termination Procedure
Applicable
SIP-3020 SIP-4010
models
(1) After you have adjusted all sensor items, securely tighten all
adjustment screws that you have loosened. Finally, securely
tighten the bottom fixing screws.
2
Cautions>>
• If you need to adjust the detection area again, be sure
to loosen the ¿ xing screw. If you try to move the main
unit without loosening the ¿ xing screw, the unit may be
damaged.
• When you mount the cover, place the excessive nylon
wire loop in the main unit. If the wire has been pinched
by the window and the cover, rain drops may be able to
enter into the main unit.
(2)
Mount the cover.
SIP-404 SIP-3020CAM DN
1
Adjustment screw
Fixing screw
10

OPERATION TEST

10-1 If There is a Public Street Where a People
Walk or Cars Drive by the Detection Area
Points>>
Reduce the size of the detection area so that it does not
include any public streets.
(1)
Check to see that the arrow of the main unit is within the
width of "Angle adjustment guide" on the adjustment screw.
Using the area viewfinder, check to see that the detection
(2)
area does not include any public streets.
(3)
If the detection area does go beyond a public street,
correct the vertical angle of the main unit.
However, exercise care so that the arrow does not move
away significantly from the "Angle adjustment guide"
position.
If the arrow does move away signi¿ cantly from
the "Angle adjustment guide" position:
Mask the far area detection area using the masking plate
or by using the far area masking switch. You may be
required to also mask the near area detection area under
specific sensor installation conditions (see Steps 5 and 8).
(4) When a person walks along the street or a car drives along
it, check the detection area using the walk tester.
Points>>
You cannot mount and use both the area viewfinder and
walk tester simultaneously.
Cautions>>
The detection area may increase if there is a large
difference in temperature between the moving object and
the background.
Cautions>>
A heat source beyond the detection area may cause a
false alarm due to the reflection of heat off the ground.
Examples of types of surfaces that reflect include water
(puddles), wet roads, smooth concrete surfaces and
asphalt roads.
If the source of the heat is strong and/or the reflection
rate is high, the detection distance will be longer than
required and may detect unnecessary objects beyond the
target area. Therefore, select the detection range position
according to the ground conditions of the installation site.
- 10 -