Publicidad
Idiomas disponibles
Idiomas disponibles
SP6570 16 gallon detach
Filter Assembly
1. Carefully slide the filter over the filter
cage, sliding it over the center ring
covering the 3 slots until the filter
stops against the lid.
2. Place the hole in the filter plate over
threaded stud of the filter cage.
3. Gently push on the filter plate to seat
the rubber ring of the filter inside the
circular channel of the filter plate.
4. Place filter nut onto threaded stud and
tighten it down. Finger tighten only.
NOTE: Lever of filter nut should be away
from plate as shown.
IMPORTANT: Do not overtighten as this
may deform or crack the filter plate, filter
cage, or filter.
NOTE: Your filter has a red stripe that
matches an in-store displayer. When you
visit your local Sears store, just remem-
ber the color of your stripe for the correct
size filter.
Vac Assembly
1. Locate the lid assembly and the
drum/caddy assemblies (assembled
earlier).
2. Position the lid assembly with the inlet
of the unit located in line with the drain
cap and the vac label on the vac.
Allow the assembly to rest on the vac
drum.
3. Rotate both latches down until you
hear the latches snap over the lip of
the drum.
12/8/04
8:47 AM
Page 7
Filter Nut
Lever
Snap
Latch
Down
7
Filter Nut
Filter Plate
Filter
Red Stripe
Threaded
Screw
Filter Cage
Slots (3)
Vac Label
Inlet
Drain
Publicidad
