Publicidad
Idiomas disponibles
Idiomas disponibles
If these batteries need replacing, remove the small screw on the rear of the Receiver which houses the
batteries (center area of image on right above).
Settings and Operation of the Receiver
or "Down" buttons to make changes. Press the "CLOCK" after each setting is correct. The
settings in sequence will be – 12 or 24 hour format/hour/minute/year/day & month or month &
day format/ month/date/weather forecast icon/exit. Then by pressing the clock you can switch
between the time/month & day/day of week in English language.
Moon Phase – will automatically be seen near the center of the display.
Heat Index – combines the effects of temperature and
humidity and is the apparent temperature of how hot the
heat/humidity combination makes it feel. You push the button
on the rear of the Receiver labeled "Heat Index/Dew Point" to
see the data indoors or outdoors (by switching the
"Channel/Snooze" button or by having the indoor & outdoor
information automatically in switching mode.
Dew Point – is the saturation point of the air, or the
temperature to which the air has to be cooled in order to get
condensation. Push the "Heat Index/Dew Point" button to obtain the information the same way
as noted above under "Heat Index".
Memory of Maximum/Minimum Data – you obtain the maximum and minimum of the indoor
and outdoor temperature/humidity/heat index/dew point by pushing the "MEM" button on the
rear of the Receiver. To clear the memory readings, press and hold the "MEM" button for a few
seconds.
Synchronize Remote Sensor – Press and
hold the "Channel/Snooze" button on the
Receiver and you will hear a beep when
the unit is searching for the remote.
Indoor & Outdoor Temperature & Humidity – can be displayed on the
Receiver. Press the "Channel/Snooze" button on top of the Receiver to
switch from "Indoor" data to "Outdoor" data (Channel 1). You can also
have the indoor & outdoor information automatically switch about every
four seconds when you push the "Channel/Snooze" button where you see
an icon than means in "switch" mode. Colorful bar graphs (red for
temperature and blue for humidity) change as the information changes.
Data displayed in "C" or "F" – on the rear of the Receiver you will see a
button and you can push it to change from "C" (Centigrade) or "F"
(Fahrenheit) for the display you desire.
Clock & Calendar – Press "CLOCK" on the rear of the Receiver and
hold down for a couple of seconds to enter the setup mode. Use the "Up"
2
Publicidad
