Remote Control - Rowenta AU4010F0 Instrucciones De Uso

Remote control

The remote control uses 2 x AAA or LR03 1.5V batteries which are not included.
To change the remote's battery, remove the cover on the back of the remote controller and insert
batteries with the (+) and (-) poles pointing in the proper direction.
Remove the batteries if the remote control is not used for a month or longer.
Remote control operations are identical to the functions on the control panel.
TROUBLESHOOTING
Trouble
The appliance does not start
The appliance stops running during operation
The appliance does not run and water full indi-
cator is lit
LEDs display "E1" or "E2"
SHOULD A PROBLEM ARISE
Never dismantle the appliance yourself because R290 gas requires specific agreement for repairing.
A poorly repaired appliance may be dangerous for the user.
Do not use the appliance and contact a specific Approved Service Centre if:
• The appliance has broken.
• Unit or its power cord is damaged,
• If your appliance does not work properly.
You can find a list of specific Approved Service Centres on Rowenta website.
HELP PROTECT THE ENVIRONMENT!
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a waste collection point or an approved service centre so that it can be disposed of
correctly.
Do not throw away the batteries with your household waste : instead, bring them to anyone
of the special battery collection points.
These instructions can also be found on our internet site www.rowenta.com
Analysis
- Please wait 3 minutes and start again,
protector device may be preventing unit from
working.
- The plug is not properly plugged.
- Set temperature is too high.
- The louver is not opened.
- Air outlets are blocked by obstacles or hose is
obstructed
- Air inlets (filters) are blocked by dust
- Water needs to be drained : please refer to
paragraph "control panel – B"
- Drainage hose is obstructed or twisted
- Please refer to a specific Approved Service
Centre.
19
EN