Setting To Work - Connection To The Power Supply; Warning Labels - Nilfisk VHS110 ClassIIDiv2 Manual De Instrucciones

Setting to work - connection to the power
supply
WARNING!
■ Make sure there is no evident sign of damage to
the vacuum cleaner before starting work.
Before plugging the vacuum cleaner into the
■
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■ Plug the vacuum cleaner into a socket with a
correctly installed ground contact/connection.
Make sure that the vacuum cleaner is turned off.
■ The plugs and connectors of the power supply
cords must be protected against splashes of
water.
■ Check the proper connection to the electrical
mains.
■ Use the vacuum cleaner only when the cord
that connects to the electricity mains is in good
condition (damaged cords could lead to electric
shock!).
■ Regularly check there are no signs of damage,
excessive wear, cracks or aging on the electric
cord.
WARNING!
When the device is operating, do not:
■ Crush, pull, damage or tread on the cord that
connects to the electrical mains.
Only disconnect the cord from the electrical
■
mains by removing the plug (do not pull the cord).
■ Only replace the power supply cord with one of
the same type as the original: SOOW. The same
rule applies if an extension is used.
■ The cord must be replaced by the manufacturer's
Service Center staff or by equivalent qualified
personnel.

Warning labels

Figure 3
Labels:
1. Warning: Explosion proof plug installed shall be certified
and be suitable for the hazardous area that the vacuum
is installed in
2. Warning: To reduce the risk of electric shock - do not use
outdoor
Caution: Open circuit before removing cover and keep
covers tight while circuits are alive
Warning: Explosion hazard - use only Nilfisk hose
Warning: The vacuum must be cleaned only with a damp
cloth
05/2016
Extensions
If an extension cord is used, make sure it is suitable for the
power input and protection degree of the vacuum cleaner.
Cord= 14/3 SOOW/600V
WARNING!
The vacuum cleaner's power socket must be protected
by a differential circuit-breaker with surge current
limitation that shuts off the power supply when the
current discharged to the ground exceeds 30 mA for
30 ms or an equivalent protection circuit.
WARNING!
Never spray water on the vacuum cleaner: this could
be dangerous for persons and could short circuit the
power supply.
5
VHS110 ClassIIDiv2
US
C420