Philips HB 814 Manual Del Usuario página 7

12
2
1
Setting the timer
- Insert the mains plug into a wall socket.
13
Note: the timer can be set up to a maximum of 60 minutes.
If you wish to treat both sides of your body directly after
each other it is advised to reset the timer just before the
set time has elapsed.
Doing so, you avoid a waiting period of at least three
minutes (which would otherwise be necessary before the
lamps can be started again).
- Unlock the locking handle
for height adjustment (H) by
sliding the collar downwards.
Simultaneously slide the
stand (G) out till approx.
85 cm (33") above the bed
(fig. 12).
Use the tape measure (P).
- Release the collar.
- Use the table in these
instructions for use and your
personal notes.
- Put on the supplied
protective goggles.
- Set the timer to the session
time required (fig. 13).
- Position yourself under the
solarium.
- Once the set time has
elapsed, the timer will switch
off the solarium
automatically.
After the UV tanning session
• On one of the session memos you can note down how
many sessions you have had. There are two such memos,
for two users.
• Let the solarium cool down for 15 minutes before folding it
up and storing it away.
Make your solarium transportable:
- Wind the mains cord and store it in the storage compartment
(B) . Be careful that it does not get stuck when the upper
casing is folded downwards.
14
2
15
16
3
17
18
7
- Release the height
adjustment lock (H) by
sliding the collar downwards.
1
Simultaneously slide in the
stand (fig. 14). Then release
the collar.
- Rotate the upper casing a
quarter turn (fig. 15).
- While lifting the upper casing
a little with one hand, unlock
the upper casing with the
other hand. To unlock, slide
the two lips (I) downwards
2
(fig. 16).
- Carefully, let the upper
casing come into a vertical
position (fig. 17).
- Release the two lips (I).
- Lower the stand with the
upper casing carefully onto
the lower casing (R)
(fig. 18).