Gewiss Chorus GW 10 754 Manual De Instrucciones página 28

PROGRAMMING WITH THE EASY CONFIGURATOR
Configuration parameters (Easy) - actuator section
Once the required function has been created, the operating parameters of the actuator can be set.
The available parameters, in relation to the function created, are listed in the tables given below.
The value underlined is the default value.
Function: timer mode
Parameter: switch-on time
not active
1 second
2 seconds
3 seconds
5 seconds
10 seconds
15 seconds
20 seconds
30 seconds
45 seconds
1 minute
1 minute 15 secs
1 minute 30 secs
2 minutes
2 minutes 30 secs
3 minutes
5 minutes
15 minutes
20 minutes
30 minutes
1 hour
2 hours
3 hours
5 hours
12 hours
24 hours
Function: timer mode
Parameter: pre-warning time
no pre-warning
15 seconds
30 seconds
1 minute
no timing
relay activated for 1 second
relay activated for 2 seconds
relay activated for 3 seconds
relay activated for 5 seconds
relay activated for 10 seconds
relay activated for 15 seconds
relay activated for 20 seconds
relay activated for 30 seconds
relay activated for 45 seconds
relay activated for 1 minute
relay activated for 75 seconds
relay activated for 1.5 minutes
relay activated for 2 minutes
relay activated for 2.5 minutes
relay activated for 3 minutes
relay activated for 5 minutes
relay activated for 15 minutes
relay activated for 20 minutes
relay activated for 30 minutes
relay activated for 1 hour
relay activated for 2 hours
relay activated for 3 hours
relay activated for 5 hours
relay activated for 12 hours
relay activated for 24 hours
no pre-warning
pre-warning 15 seconds before the deactivation of the relay
pre-warning 30 seconds before the deactivation of the relay
pre-warning 1 minute before the deactivation of the relay
28