Troubleshooting - Oreck AIRT Serie Guía De Usuario

Trouble-
shooting.
Service problems that
appear to be major can
often be solved easily.
You can be your own
troubleshooter by
reviewing this guide.
All other servicing
should be done by an
Oreck authorized
service center.
E N G
P P r r o o b b l l e e m m
Unit does not turn on.
"Check Collector Cell"
has turned red.
"Check Collector Cell"
light is flashing red.
Unit does not
remove pollutants.
Unit sparks, crackles
and pops.
"Check Odor Absorber"
light has turned red.
Does not remove odor.
Unit still does not
operate properly.
L I S H
C C h h e e c c k k W W h h a a t t t t o o d d o o
• Power Cord • Plug in the power cord.
• Power Button • Set power button for desired
blower speed.
• Cabinet Door • Make sure cabinet door is closed
securely.
• Collector Cell • Wash collector cell. Make sure it
is thoroughly clean and dry before
reinstalling.
• Collector Cell • Collector cell may need cleaning.
Clean collector cell.
• Collector cell may not be completely
dry. Allow it to air dry longer.
• Collector cell may be damaged.
Contact Oreck for service.
• Collector Cell • Wash collector cell. Make sure it is
thoroughly clean and dry before
reinstalling.
• Collector Cell • Sparking or popping noise (arcing)
occurs when a large particle is
captured in the collector cell.
• If the unit is arcing excessively, the
collector cell may be dirty. Try
cleaning the collector cell.
• If excessive arcing continues after
proper cleaning, the cell may be
damaged or wet. If damaged,
contact Oreck for service.
• Odor Absorber • Replace odor absorber if desired.
• If the odor absorber is not replaced,
remove old odor absorber to turn off
"Check Odor Absorber" light.
• Odor Absorber • Vacuum odor absorber with a soft
brush attachment if dirty. Do not
use any liquids to clean the odor
absorber.
• Replace odor absorber if desired.
• Check all the • Contact Oreck for service.
above points.
11