Function And Operation; Service Life - SATA 05213 Manual Del Uso

Function and operation :

1） Please fully charged （2 to 3 hours） when use at first time, to extend battery life.
2） Please heat for more than 5 minutes before use. The glue gun has the function of anti dropping glue. The glue gun should be placed
vertically in the process of using. Please be sure to put it upside down to prevent unnecessary damage caused by glue backflow.
3） In the process of use, pull the trigger gently to release the glue. Do not pull the trigger hard to avoid damaging the glue gun. The
adhesive force of glue is proportional to the time of melting glue.
4） Insert the 7mm-7.2mm rubber bar into the heating channel from the rear, and use it after preheating.
5） After use, the cooling equipment can be stored.
Charging/using :
1） The battery was partially charged at the time of supply. The battery must be fully charged （about 2.5 hours） during initial use to
ensure full power.
2） Do not use during charging.
3） The interruption during charging process will not cause damage to the battery. The battery can be charged at any time without
shortening the battery life.
Service life：
Through the "battery electronic protection technology" to prevent deep battery discharge. When the battery is discharged, it will be
closed by a protective circuit and will no longer heat the adhesive.
Use:
Button Orange LED
ON/OFF
ON
8
05213
Green LED
-
-
中文
EN
Blue LED
Battery charging process, Device usage is
End charging, battery fully charged
- The device can be used after heating for 3-5
Turn off the blue LED then stop work,
When the blue light automatically extinguish,
means the battery is running out, and start the
charging process via the USB charger
DE RU KO PT JA
restricted currently
Turn the button ON,
minutes
ES