Maintenance And Care; Weekly Maintenance; Monthly Maintenance - Uline H-725 Manual De Instrucciones

LOAD TAPE ROLL CONTINUED
2. Reposition the roller for gummed in or gummed
out tapes.
Figure 10A
OPERATION
1. Pull feed lever forward until the lever cam points to
the desired tape length on the BLACK scale.
Figure 11
CAUTION: Only trained personnel should be
allowed to operate or service this machine.

WEEKLY MAINTENANCE

Wash the moistening brush with soap and warm water.
Rinse thoroughly with water.
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 4 OF 12
SETUP INSTRUCTIONS CONTINUED
GUMMED OUT
Feed Lever
Set Cam

MAINTENANCE AND CARE

3. Insert tape roll between guide plates and over roller
so tape is positioned gummed side down. Feed the
tape under the upper paper guide and white wheel.
(See Figures 10A & 10B)
Figure 10B
OPERATION OPERATION
NOTE: Pull the lever with even pressure – Do not
yank it. (See Figure 11)
2. Release the lever to automatically cut the tape – Do
not push the lever back.
NOTE: To cut very short lengths (4-8"), you may
have to push the lever back gently.
3. To preset a second tape length: (for 'H' closings,
different box sizes, etc.): Loosen the clamping nut
and set the lever cam to point to the desired length
on the RED scale.
NOTE: When using two lengths, the longer
length should be set on the RED scale.

MONTHLY MAINTENANCE

1. Lubricate the cutting blades with a drop of oil.
2. Wash the rubber wheel with water. Do not grease or
oil the wheel. Access the wheel by removing the
upper paper guide.
3. Clean the water reservoir with soap and water.
Rinse thoroughly.
1-800-295-5510
uline.com
GUMMED IN
0620 IH-725