Technical Data - MO-EL 725 Manual De Uso Y Mantenimiento

INSTALLATION
The hand dryer has been specifically designed for vertical attachment on the wall
with the air outlet toward the bottom.
The appliance can also be installed by connecting it permanently to the power
supply, using the hole "C" in Fig. 5. In this case an overvoltage category III bipo-
lar circuit breaker, with contact opening distance of at least 3 mm must be fitted
upstream from the supply line.
Make sure that the wall where you plan to mount the appliance is solid and free
of electrical cables or water pipes inside.
For safety reasons, never attach the device near bath tubs, wash basins, show-
ers, or other fittings where there may be water.
This hand dryer must be installed out of the range of a person using the bath or
the shower.
This machine can be installed and used in bathroom, washroom, kitchen, etc. The distance
shall be around 110 cm from the ground. Keep certain distance between the dryer and the
door to avoid hit when opening and closing the door.
1. Drill 4 holes in the wall according to Fig. 4 and bury the expansion tubes into the holes.
2. Screw out the 2 hexagon socket head cap screws from the shell by means of the hexa-
gon wrench enclosed with the appliance (Fig. 1).
3. Discharge the shell (Fig. 2) and meanwhile disconnect the sensor wire and the earth wire
(Fig. 3); please do not use too much strength when opening the shell because the wires
could be damaged .
4. Fix the holder to the wall by means of the 4 fixing screw enclosed with the appliance
(Fig. 5); then connect sensor wire and the earth wire (Fig. 6).
5. Insert the shell into the holder from the top, pressing tightly the bottom of the holder at
the same time and paying attention that the wires do not remain clipped between the
parts; then fasten the shell by means of the 2 screws and the hexagon wrench (Fig. 6).
6. Having fixed the appliance to the wall, connect it to the power supply.
OPERATING
After washing your hands, put them near to the hole located at the bottom of the nozzle air
diffuser and push the button in the frontal part to switch on. The warm air flows immediately.
Push the button again to stop the flow. A safety device causes automatic shutdown after 10
seconds of continuous use; push the button again to restart. To short the work time, please
shake the water away from your hands before the use.
The nozzle can be rotated to direct the air flow. To prevent accidental falls of objects inside,
it is suggested to locate the hole downward when the appliance is not in use.

TECHNICAL DATA

Power supply
Rated power
Air speed
Protection level
Dimensions (cm)
AC 230 V ~ 50 Hz
27 x 20 x 23 (H)
6
2300 W
22 m/s
IPX1